CM220 Chipper 6. MAINTENANCE 6-8
©GreenMechLtd 6-8 08/17
6.23 Fault finding
Fault Check Action Page
Engine will not start Battery Recharge 6-7
Fuel Fill tank 6-4
Oil pressure Check Oil level 6-4
Thermal cut-out Check operation 3-2
Fuses Check 6-9
Engine not at correct speed Clutch cut-out Check operation 3-2
No stress light not on Fuses, cut-outs Check operation 6-9
Flywheel will not start Clutch Adjust 5-2
Drive belts Replace 6-6
Feed rollers do not turn Control bar Reset and check 3-2
Hydraulics Check solenoid valve 5-3
Feed will not reverse Control bar Rest and check 3-2
Hydraulic valve Check operation
Discharge does not flow Discharge chute Check for blockage 5-1
Flywheel Check for blockage 5-1
Wood unevenly chipped
Machine unsteady Support leg Set to correct position 5-1
Unusual noise(s) Flywheel and bearings Check and replace 6-5
To Next Page
Loading...