CM220 Chipper 7 STORAGE 8 DISPOSAL 7-1
©GreenMechLtd 7-1 08/17
7.1 Storage
Thoroughly clean machine and note any replacement parts required.
Carry out 250 hour service if not already done. Refer to Section 6
Fit replacement parts when available.
Remove battery (where fitted) Refer to 6.13
Drain fuel (engine models)
If machine is to be stored for more than 3 months, place on axle stands to remove weight
from wheels*.
7.2 Removal from Storage
Charge battery and refit Refer to 6.13
Check tyre pressures* Refer to 6.14
Check brake operation* Refer to 6.15
Carry out machine preparation as necessary Refer to Section 4
*If applicable
8 Disposal
When machine is finally scrapped, the following items should be disposed of only at
authorised waste disposal facilities.
Engine oil. Hydraulic oil. Antifreeze. Battery. Tyres.
If in doubt, consult Local Authority environmental department.
Major non-ferrous items such as covers and hydraulic hoses may also be disposed of
separately.
To Next Page
Loading...