Greiner Vibrograf ACS921

To Next Page

To Previous Page

Here you can define the oscillation parameters for each process step

The following settings are stored by default:

SPEED (rpm) STOP TIME (s) ROTATION TIME (s)

Main Page

Table of Contents2
General Instructions5
Information about this Operating Manual5
Information on Customer Service5
Intended Use5
Improper Use5
Safety Instructions6
Symbols6
Safety Instructions and Warnings6
Binding Instructions7
Emergency Stop System7
Door Monitoring System8
Venting System9
Device Venting9
Venting Via Activated Carbon Filter9
Venting with Hose Connection10
Function, Set-Up and Commissioning11
Description of Function11
Setting up11
Commissioning12
Insert the Liquid Container and Position the Turntable13
Inserting the Liquid Container13
Position the Turntable (if Necessary)14
Inserting Baskets15
Operation16
Screen17
Programme17
Process17
Settings17
Here You Can Set the Language, Date and Time, Display and Service17
Settings18
Process No. 1 (Ultrasound Bath)18
Process Nos. 2-5 (Cleaning and Rinsing)19
Process No. 6 (Drying)19
Programme21
Create Programme21
Standard Programmes (Pre-Installed)21
Start Programme24
Quit Programme25
Link Programmes25
Language26
Date Time26
Display27
Service27
Bath Change31
Procedure in the Event of Unwanted Spillage of Liquids33
Using the USB Connector Socket34
Baths and Containers36
Position and Baths36
Container36
Cleaning Fluids37
Greiner Vibrograf WF537
Greiner Vibrograf GS50037
Greiner Vibrograf S-338
Isopropyl Alcohol38
Recommendations39
Technical Data40
Dimensions41
Service and Maintenance, Malfunction42
Service and Maintenance42
Fault Messages, Troubleshooting, Fault Journal42
Fault Messages42
Fault Memory46
Declaration of Conformity47
Disposal49
Appendix50
Spare Parts50
Sensors50
Actuators51
Motors51
Fan53
Drive Belt53
Original Accessories54
Activated Carbon Filter54
Baskets54
Cleaning Fluids54

Greiner Vibrograf ACS921 - Page 30

Table of Contents