GRISWOLD PUMP COMPANY Introduction Page 3
Installation, Operation and Maintenance Manual
Griswold Model 811
Griswold Pump Company Introduction Page 5
Failure to read and comply with installation, operation and maintenance instructions will
void the responsibility of the manufacturer and may result in bodily injury or equipment
damage.
Operating procedure, practice, etc, w
hich if not correctly followed, could result in personal
injury or loss of life.
Operating procedure, practice, etc, which if not followed could result in damage or
destruction of equipment.
Operating procedure, condition, etc, which is essential to observe.
Foreword
This manual is intended to assist those who are involved with the installation, operation and
maintenance of the Griswold Model 811 ANSI B73.1 Process Pump. These instructions should
be reviewed in their entirety and should be thoroughly understood prior to installation, operation
or maintenance on the pumping unit. If there are any questions, contact either Griswold Pump
Company or your local authorized Griswold representative prior to proceeding.
This manual should be kept as a part of the permanent records for the pump and should be
readily accessible as a reference to anyone working on the pumping unit. Referenced items
numbers can be found on the cross sectional drawings that are located in Appendix VIII.
These pumps have been designed for safe and reliable operation when properly used and
maintained in accordance with instructions contained in this manual. A pump is a pressure-
containing device with rotating parts that can be hazardous. Operators and maintenance
personnel must realize this and follow safety measures. Griswold Pump Company shall not be
liable for physical injury, damage or delays caused by a failure to observe the instructions in this
manual.
Throughout this manual the words WARNING, CAUTION, and NOTE are used to indicate
procedures or situations, which require special operator attention.
DEFINITIONS
WARNING
WARNING
CAUTION
To Next Page
Loading...