G0516 Lathe/Mill -13-
This section will cover the minimum assembly
and adjustment instructions needed to begin
operation. For best results, complete the assem-
bly in the order provided in this manual and then
read the remaining portion of the manual before
attempting any type of operations.
Do not connect the
machine to power at this
time. The machine must
remain unplugged
throughout the entire
assembly process. Failure
to do this may result in
serious personal injury.
Beginning Assembly Install Support Leg
Figure 4. Installing support leg.
To install the support leg:
1. Get the help of an assistant.
2. Tip the lathe forward and have your assistant
thread the leg w/attached foot into the lathe
stand as shown in Figure 4.
3. Adjust the support leg until it just makes con-
tact with the surface of your workbench or
stand.
4. Tighten the jam nut so the leg will not move.
Jam Nut
Leg Support
To Next Page
Loading...
Need help?
General
