G0603X 25" Extreme Series Planer
-15-
Figure 9. Minimum working clearances.
Floor Load
Refer to the Machine Data Sheet for the weight
and footprint specifications of your machine.
Some residential floors may require additional
reinforcement to support both the machine and
operator.
Placement Location
Consider existing and anticipated needs, size of
material to be processed through each machine,
and space for auxiliary stands, work tables or
other machinery when establishing a location for
your new machine. See Figure
9 for the minimum
working clearances.
Unsupervised children and
visitors inside your shop
could cause serious per
-
sonal injury to themselves.
Lock all entrances to the
shop when you are away and
DO NOT allow unsupervised
children or visitors in your
shop at any time!
The unpainted surfaces are coated with a waxy
oil to protect them from corrosion during ship
-
ment. Remove this protective coating with a sol
-
vent cleaner or citrus-based degreaser such as
Grizzly’s G7895 Degreaser. To clean thoroughly,
some parts may need to be removed. For opti
-
mum performance from your machine, make
sure you clean all moving parts or sliding con
-
tact surfaces that are coated. Avoid chlorine-
based solvents, such as acetone or brake parts
cleaner, as they may damage painted surfaces
should they come in contact. Always follow the
manufacturer’s instructions when using any type
of cleaning product.
These Items are coated and must be cleaned:
1. Cutterhead
2. Feed Rollers
3. Table
4. Table Ways
5. Infeed and Outfeed Extension Wings and
Wing Mounting Surfaces
Site ConsiderationsClean Up
Gasoline and petroleum
products have low flash
points and could cause
an explosion or fire if
used to clean machinery.
DO NOT use gasoline or
petroleum products to
clean the machinery.
Many of the solvents
commonly used to clean
machinery can be toxic
when inhaled or ingest
-
ed. Lack of ventilation
while using these sol
-
vents could cause seri
-
ous personal health risks
or fire. Take precautions
from this hazard by only
using cleaning solvents
in a well ventilated area.
To Next Page
Loading...
Need help?
General
