Grizzly G0645 - Inventory

G0645 Benchtop Mortising Machine
-11-
Inventory
The following is a description of the main compo-
nents shipped with your machine. Lay the compo
-
nents out to inventory them.
Note:
If you can't find an item on this list, check
the mounting location on the machine or examine
the packaging materials carefully
. Occasionally
we pre-install certain components for shipping
purposes.
Box 1: (Figure 3) Qty
A. Hand Lever ................................................. 1
B.
Gas Spring ................................................. 1
C. Tool Storage Rack ......................................
1
D. Hold Down .................................................. 1
E. Mortising Chisel and Bit
1
⁄4" ........................ 1
F. Mortising Chisel and Bit
5
⁄16" ....................... 1
G. Mortising Chisel and Bit
3
⁄8" ........................ 1
H. Mortising Chisel and Bit
1
⁄2" ........................ 1
I. Extension Block .......................................... 1
J. Hardware & Tools (Not Shown) ................. 1
— Chuck Key/ Hex Wrench 4mm ............... 1
— Hex Wrench 4mm .................................. 1
— Hex Bolts M8-1.25 x 80 (Extension) ...... 4
SUFFOCATION HAZARD!
Immediately discard all plas-
tic bags and packing materi
-
als to eliminate choking/suf
-
focation hazards for children
and animals.
If any nonproprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Figure 3. G0645 inventory.
A
B
C
D
E
H
I
F
G