Model G0758 (Mfd. Since 2/14)
-13-
Figure 6. Inventory included with machine.
K
A
C
D
E
G
B
I
J
L
M
F
H
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
Inventory (Figure 6) Qty
A. Handwheel Handles w/Screws ................... 3
B. Bottle for Oil ............................................... 1
C. Toolbox ....................................................... 1
D. Drill Chuck Arbor R-8 x B-16 ...................... 1
E. Standard Screwdriver ................................. 1
F. Phillips Screwdriver .................................... 1
G. Spindle Pin ................................................. 1
H. Open-End Wrench 8/10mm ........................ 1
I. Open-End Wrench 12/14mm ...................... 1
J. Open-End Wrench 17/19mm ...................... 1
K. Drill Chuck 3–16mm w/Chuck Key ............. 1
L. T-Bolt M8-1.25 x 55 Assemblies ................. 2
M. Hex Wrenches 2.5, 3, 4, 5, 6mm ......1 Each
To Next Page
Loading...
Need help?
General
