-14-
Model G0815 (Mfd. Since 09/18)
Inventory
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
Inventory (Figure 6) Qty
A. Dust Hood .................................................. 1
B. Phillips Head Screws 10-24 x
3
⁄8 ................ 4
C. Lifting Bars ................................................. 4
D. Knife-Setting Jig ......................................... 1
E. Feed Rate Control Knob
3
⁄8 - 1 6 ................... 1
F. Open-End Wrenches 8/10, 12/14mm ...1 Ea.
G. T-Handle Hex Wrench 5mm ....................... 1
H. Hex Wrenches 2.5, 3, 4, 6mm ..............1 Ea.
Figure 6. Model G0815 loose inventory.
E
F
G
H
D
C
B
A
To Next Page
Loading...
Need help?
General
