-20-
Model G0815 (Mfd. Since 09/18)
Test Run
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Clear all setup tools away from machine.
2. Connect machine to power by inserting power
cord plug into a matching receptacle.
3. Press START button (see Figure 17) to turn
machine ON. Verify motor starts up and runs
smoothly without any unusual problems or
noises.
4. Press STOP button (see Figure 17) to turn
machine OFF.
Congratulations! The Test Run is complete.
START
Button
STOP
Button
Figure 17. Location of START and STOP
buttons.
To Next Page
Loading...
Need help?
General
