-32-
Model G0815 (Mfd. Since 09/18)
Lubrication
Your planer features bearings that are lubricated
and sealed at the factory. These bearing do not
require any further attention unless they need
to be replaced. If a bearing fails, your planer will
probably develop a noticeable rumble or vibration,
which will increase when the machine is under a
load. The bearings are standard sizes and can be
replaced through Grizzly.
Follow the maintenance schedule on Page 31 and
the following procedures to properly lubricate the
other planer components, which are essential for
long life and trouble-free operation of your planer.
NOTICE
Failure to follow reasonable lubrication
practices as instructed in this manual for
your machine could lead to premature fail-
ure of components and void the warranty.
Feed Roller Bushings
Oil Type ................SB1365 or ISO 68 Equivalent
Oil Amount ...........................................2–3 Drops
Frequency ................ Every 8 Hours of Operation
The infeed and outfeed rollers rotate inside bush-
ing blocks on both ends of the rollers. Add 2–3
drops of ISO 68 machine oil to the center hole of
the four feed roller tension adjustment bolts on top
of the head casting (see Figure 41).
Figure 41. Lubrication of feed roller bushings.
Lubricate
Here
Figure 40. Recommended products for machine
lubrication.
SB1365—South Bend Way Oil-ISO 68
T26419—Syn-O-Gen Synthetic Grease
To Next Page
Loading...
Need help?
General
