EasyManuals Logo

Grizzly G0886 User Manual

Grizzly G0886
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #20 background imageLoading...
Page #20 background image
-18-
Model G0886 (Mfd. Since 01/19)
Lifting & Placing
DO NOT attempt to lift or move machine without
using proper lifting equipment (such as a forklift)
and assistance from other people. Each piece of
lifting equipment must be rated for at least 2250
lbs. to support dynamic loads that may be applied
while lifting.
Review the Power Supply section beginning on
Page 11, then prepare a permanent location for
the machine.
IMPORTANT: Make sure prepared location is
clean, flat, and reasonably level.
This is an extremely heavy machine! Serious
personal injury or death may occur if safe
lifting and moving methods are not fol-
lowed. To be safe, you will need assistance
and power lifting equipment when moving
shipping crate and removing machine from
crate. Seek assistance from a professional
rigger if you are unsure about your abili-
ties or maximum load ratings of your lifting
equipment.
To lift and place machine:
1. Move machine over its prepared location
while still inside shipping crate.
2. Remove top and sides of shipping crate, then
place small items aside in safe location.
Note: Do not destroy shipping crate and
packaging until after Test Run.
3. Remove (4) lag screws and flat wash-
ers that secure machine to shipping pallet
(see Figure 10).
Figure 10. Machine secured to shipping pallet.
Lag Screw and Flat
Washer (1 of 4)
Machine Foot
(1 of 4)

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Grizzly G0886 and is the answer not in the manual?

Grizzly G0886 Specifications

General IconGeneral
BrandGrizzly
ModelG0886
CategorySaw
LanguageEnglish

Related product manuals