Grizzly G0886 User Manual

Model G0886 (Mfd. Since 01/19)
-53-
Hydraulic System
Symptom Possible Cause Possible Solution
Hydraulics are not
functioning.
1. Hydraulic fluid level is low.
2. Hydraulic system is leaking.
3. Flow blocked or impeded.
4. Control panel wiring at fault.
5. Hydraulic pump at fault.
1. Check/fill hydraulic fluid level (Page 46).
2. Inspect/test for leaks/repair.
3. Make sure hydraulic line(s) are not pinched or
damaged.
4. Check that hydraulic pump motor is running and
that solenoids are activating (indicated by red LED
in solenoid plug). Repair/replace if at fault.
5. Test/repair/replace.
Vise does not open/
close.
1. Vise valve solenoids at fault.
2. Vise valve solenoids connections are bad.
3. Vise hydraulic system is leaking.
4. Control panel wiring at fault.
5. Hydraulic pump at fault.
1. Test/repair/replace.
2. Check solenoid plugs.
3. Test for leaks/repair.
4. Check that hydraulic pump motor is running and
that solenoids are activating (indicated by red LED
in solenoid plug).
5. Test/repair/replace.
Headstock doesn't
raise/lower.
1. Headstock valve solenoids at fault.
2. Headstock valve solenoids connections are
bad.
3. Headstock hydraulic system is leaking.
4. Control panel wiring at fault.
5. Hydraulic pump at fault.
1. Test/repair/replace.
2. Check solenoid plugs.
3. Test for leaks/repair.
4. Check that hydraulic pump motor is running and
that solenoids are activating (indicated by red LED
in solenoid plug).
5. Test/repair/replace.
Hydraulic tank fluid
burnt or has tan
discoloration.
1. Hydraulic fluid is old or contaminated with
water.
1. Replace hydraulic fluid (Page 46).

Grizzly G0886 Specifications

General

Brand	Grizzly
Model	G0886
Category	Saw
Language	English