Grizzly G0938 - Making Inside Cuts; Making Bevel Cuts

-28-
Model G0938 (Mfd. Since 03/21)
Inside cuts can easily be made with the scroll saw
by threading the blade through a hole drilled in the
workpiece.
Making an inside cut:
1.
DISCONNECT MACHINE FROM POWER!
2. Drill a
1
⁄8" hole in workpiece inside waste area
of internal cut.
3.
Remove blade from saw.
4. Insert blade through previously drilled hole in
workpiece (see Figure 30).
Making Inside Cuts Making Bevel Cuts
Figure 31. Making a bevel cut.
5. Turn saw OFF and wait until all motion has
stopped before removing waste near blade.
Figure 30. Installing blade for an inside cut.
5.
Re-install blade.
6. Adjust hold-down shoe, connect saw to
power, then perform cut.
7. When finished, disconnect saw from power,
remove blade and workpiece, then re-install
blade on saw.
Bevel cuts can be used for miters, cope joints,
and making relief or recessed projects.
Making a bevel cut:
1.
DISCONNECT MACHINE FROM POWER!
2. Loosen table lock knob, then adjust table to
desired angle. Tighten knob to secure.
3
. Connect saw to power.
4. Using principles in Making Standard Scroll
Cuts on Page 27, feed workpiece slowly and
evenly into blade, remembering not to force
workpiece through cut (see Figure 31).