Grizzly G0938 - Replacing LED Work Light

-34-
Model G0938 (Mfd. Since 03/21)
Replacing
LED Work Light
The LED work light can be replaced if it no longer
functions. Replace when it stops operating cor-
rectly, fails to provide light, or flashes.
Tools Needed Qty
Phillips Head Screwdriver #2 ............................ 1
Open-End Wrench 6mm.................................... 1
Replacement LED Light (P0938101)
................. 1
To replace LED work light:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove control panel and unplug LED work
light from circuit board (see Figure 39).
Figure 39. Control panel access and
connections.
LED Work
Light Wire
Circuit
Board
Control
Panel
LED Work
Light
Connector
Figure 38. Location of blade holders.
7. Adjust blade holders until blade is flat against
edge of square along its entire length.
8.
Tighten button head cap screws loosened in
Step 5.
6.
Loosen button head cap screws on upper
and lower blade holders (see Figure 38).