-18-
Model G0948 (Mfd. Since 08/21)
13. Install fence on fence rail, as shown in
Figure 18.
Note: Fence lock lever (see Figure 18)
needs to be in up position when fitting fence
onto fence rail. Once fence snaps onto fence
rail, push lock lever down to secure fence in
position.
Figure 18. Fence installed on fence rail.
Fence
Lock
Lever
Fence Rail
9. Completely raise upper blade guide assem-
bly, then place machinist's square flat on
table, against side of blade (see Figure 16).
10.
Loosen table lock lever, and tilt table until
square is flat against side of blade, as illus-
trated in Figure 16. When complete, tighten
lock lever.
Table
Square
Figure 16. Using a square to adjust table
perpendicular to the side of blade.
11.
Loosen screw on scale indicator (see Figure
15 on Page 17), set indicator to "0", and
tighten screw.
12.
Attach fence rail to front of table with (4)
M8-1.25 x 18 wing bolts (see Figure 17).
Figure 17. Fence rail attached to front of table.
Wing Bolts
Fence Rail
To Next Page
