What causes the backside of my Grizzly Saw blade to crack?
If the backside of your Grizzly Saw blade is deformed or cracked, consider these solutions: * Reduce feed rate/pressure. * Adjust blade tension. * Properly adjust blade support bearings.
Why won't the table on my Grizzly G0948 Saw tilt to the correct angles?
If the table on your Grizzly Saw does not tilt to 45 or 0 degrees, consider the following: * Calibrate the table tilt scale indicator. * Adjust the positive stop.
What should I do if the miter bar binds in the miter slot of my Grizzly G0948?
To address a miter bar that binds in the miter slot of your Grizzly Saw, you can: * Carefully clean the miter slot. * Replace the miter bar.
Provides essential safety warnings and guidelines for operating machinery.
Outlines specific safety measures for bandsaw operation and potential hazards.
Step-by-step instructions for assembling the bandsaw and its stand.
Procedures for aligning the blade to track correctly on the wheels.
Explains how to properly tension the bandsaw blade using flutter or deflection.
Details how to adjust support and guide bearings for optimal blade support.
Steps for aligning the table parallel to the blade and perpendicular to the blade.
Instructions for aligning the fence parallel to the miter slot for accurate cuts.
Provides solutions for common machine issues, from electrical problems to cutting quality.
Procedures for checking/adjusting belt tension and replacing the belt.
Instructions for checking, shimming, and adjusting the bandsaw wheels for proper alignment.
Safety precautions for working with electrical wiring and the machine's wiring diagram.
General| Motor | 2 HP, 120V/240V (prewired 120V), single-phase, 14A/7A |
|---|---|
| Blade Diameter | 10" |
| Table Size | 20-1/4" D x 27" W |
| Weight | 273 lbs. |
| Arbor Size | 5/8 inches |
| Max Cut at 90° | 3-1/8 inches |
To Next Page
