-22-
Model G7945/G7946 (Mfd. Since 09/17)
15. Screw two small lock levers into each side of
horizontal column bracket (see Figure 20).
16. Tightly thread the downfeed handles into the
hub as shown in Figure 21.
17. Slide chuck guard onto bottom of depth-stop
bracket, as shown in Figure 22.
Figure 21. Installing downfeed handles.
Downfeed
Handles
Hub
18. Secure chuck guard to bracket with (4) M4-.7
x 10 Phillips head screws and (4) 4mm flat
washers, as shown in Figure 23.
Figure 22. Chuck guard installed on depth-stop
bracket.
Depth-Stop Bracket
Figure 23. Chuck guard secured to depth stop
bracket.
Depth-Stop Bracket
Screws &
Washers
(2 of 4)
The headstock is a heavy
load. Seek assistance
before beginning this
step.
14. With the help of an assistant, lift the head-
stock over the top end of the column. When
the underside of the headstock is lined up
with the column, slide the headstock onto the
column until it stops (approximately 2").
Note: An alternate method is to lay the
headstock and column on the floor, slide
them together, tilt the assembly up, and posi-
tion the drill press upright on its base.
Figure 20. Small lock levers installed.
Small Lock Levers
To Next Page
