-36-
Model G7947/G7948 (Mfd. Since 01/21)
D3782—Lathe Chisel Set, 3-Pc.
This 3-Pc. Lathe Chisel Set will take care of most
of your spindle turning operation needs. You get
a
1
⁄8" Parting Tool,
1
⁄2" Skew Chisel, and
5
⁄16"
Spindle Gouge in a highly-protective aluminum
case. HSS blades and ash handles will last a
lifetime! Chisels measure 11
5
⁄8" overall with 7
7
⁄8"
long handles.
Figure 47. Model D3782 Lathe Chisel Set, 3-Pc.
Figure 44. Model H7827 Drill Press Table.
H7827—Drill Press Table
Add this 23
3
⁄4" wide x 11
7
⁄8" deep Drill Press Table
with 3" high fence and stop block to your drill
press for greater work support and increased
accuracy. The fence and stop block slide along
T-slots for quick, yet secure set-up and a remov-
able 3
15
⁄16" square center block allows thru drill-
ing past the table. Fits all standard drill press
tables and includes two universal table clamps.
Mortising chisel and clamps not included.
D4088—Lathe Attachment for Drill Press
Perform vertical spindle turning on your mul-
tispeed drill press with this Lathe Attachment.
Easy setup means quick change over from drill
press mode to lathe mode. A 12" tool rest allows
a maximum work piece length of 24" when the
work piece is reversed. Includes a base plate
with live center, 12" tool rest, mounting bolts, mini
screw center and spur center. Fits all drill presses
with a through hole in the table.
Figure 46. Model D4088 Lathe Attachment.
H4978—Deluxe Earmuffs - 27dB
H4979—Twin Cup Hearing Protector - 29dB
T20446—Classic Earplugs, 200-pair - 31dB
Protect yourself comfortably with a pair of cush-
ioned earmuffs. Especially important if you or
employees operate for hours at a time.
Figure 45. Hearing protection.
H4978
T20446
H4979
order online at www.grizzly.com or call 1-800-523-4777
To Next Page
Loading...
