Groeneveld BEKA-ONE - Battery Change; Flashing Signals Of The Led Strip And Troubleshooting

© Groeneveld-BEKA GmbH 2023 -23- Alle Rechte vorbehalten!
11.3 Battery change
• Proceed as described under 9.4 Insert the batteris.
Dispose of used batteries properly and professionally andaccordingtoyour
localregulations.
11.4 Flashing signals of the LED strip and troubleshooting
YoucanseethecurrentfunctionalstateofthedevicefromtheashingsignalsoftheLEDstrip.
Attention!
LED State Cause Troubleshooting
green
ON Deviceiscurrentlylubricating
Flashes every 60 s Functionalcheck(=OK,deviceactivated)
red
Flashesbriey2x
every 10 s
• Backpressure
toohigh
or
• Mechanical
blocking
Unscrew device
• Checkthelubepointfortoohighbackpres-
sure and remedy error if necessry.
• Renewbatteriesandactuateintermediate
lubricantion
Device does not
work
Replacedevice
orange
Flashes2xbriey
every 10 s
Batteryvoltage
too low
• Renewbatteries
• Actuate an intermediate lubrication