Groeneveld BEKA-ONE - Safety Instructions for Maintenance, Inspection and Assembly; Unauthorized Modification And Production Of Spare Parts; Improper Modes of Operation; Electrostatic Discharge

© Groeneveld-BEKA GmbH 2023 -7- Alle Rechte vorbehalten!
3.5 Safety instructions for maintenance, inspection and assembly
All maintenance, inspection and assembly work may only be carried out by qualied
personnelwhoissu󰀩cientlyinformedbythoroughreadingoftheuserinformation.
Generally any work at the device may only be done at complete standstill and in
pressureless and disconnected condition. Use appropriate personal protective
equipment (gogglesamongothers). The shutdown procedure of the device as described
intheoperatingmanualmustbestrictlyfollowed.
Securethedeviceagainstintentionalorunintentionalrecommissioningduring
maintenanceandrepair.Putallsafetyandprotectionarrangementsbackinplaceagain
immediatelywhentheworkisnished.
Dispose of environmentally hazardous media professionally and in accordance to
therelevanto󰀩cialprovisions.Cleanpolluted and contaminated surfaces before
maintenance. Wear protective equipment to that purpose. Observe the lubricant
manufacturer’s data sheets and safety data sheets, respectively the data sheets provided
bythemanufacturersofusedauxiliariesandworkingmaterials.
Checkthesurfacetemperatureofthedeviceasapossibleheattransferbearstherisk of
burns.Wearheat-resistantprotectivegloves!
Open light and rearestrictlyforbiddenduringanymaintenance,inspectionandrepair
due to re hazard.
3.6 Unauthorized modication and production of spare parts
Modication,repairandalterationsofthedeviceareonlyacceptedafterconsultationwith
themanufacturer.Originalsparepartsandauthorizedaccessoriesfromthemanufacturer
contribute to safety. The use of other parts can result in the loss of any liabilities for the
resultingconsequences.Groeneveld-BEKAwillnotassumeliabilityforpartsretrotbythe
operator.
3.7 Inadmissible modes of operation
Operationalsafetyofthedeviceisonlyguaranteedforappropriateuseasstatedintheoperating
manual.Neverexceedoffallbelowthelimitvaluesasstatedinthetechnicaldata.
3.8 Electrostatic discharge
Avoidelectrostaticdischarge!Thereareelectricalcomponentsintegratedintothedevices
whichyoucandestroybyelectrostaticdischargewhenyoutouchthem.Observethe
safetyprecautionsagainstelectrostaticdischargeacc.toDINEN61340-5-1/-3.Ensure
thattheenvironment(persons,workplaceandpackaging)iswellgroundedwhenhandling
the devices.
3.9 General hazard warning - Residual risk
Allcomponentsofthedevicearedesignedaccordingtovalidregulationsforthe
constructionoftechnicalsystemsregardingoperationalsafetyandaccidentprevention.
Independently thereof the use can lead to hazards for the user or third parties and for
other technical facilities. Therefore the device may only be used for its intended purpose
in technically faultless conditionandincompliancewiththerelevantsafetyregulations
andtheopertingmanual.Inspect the device and its attachment parts regularly and
checkthemforpossibledamage or leakages. Fluids could escape under high
pressure from pressurized components which have become leaky.