7.2.1 Home display
TM068915
Example of "Home" display
Pos. Symbol Description
1
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
"Home"
This menu shows up to four user-defined
parameters. You can select parameters shown as
shortcut icon , and when pressing you go
directly to the "Settings" display for the selected
parameter.
2 -
"Status"
This menu shows the status of the pump and
system as well as warnings and alarms.
3 -
"Settings"
This menu gives access to all setting parameters.
You can make detailed settings of the pump in this
menu.
See the section on the description of functions.
4 -
"Assist"
This menu enables assisted pump setup, provides
a short description of the control modes and offers
fault advice.
See the section on "assist".
5
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
This symbol indicates that the pump has been
stopped via the
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
button.
6
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
This symbol indicates that the pump is functioning
as master pump in a multipump system.
7
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
This symbol indicates that the pump is functioning
as a slave pump in a multipump system.
8
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
This symbol indicates that the pump is operating
in a multipump system. See the section on setting
up a multi-pump system.
9
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
This symbol indicates that the possibility to make
settings has been disabled for protective reasons.
See the section on the buttons on the product
("enable/disable settings").
Related information
8.1 "Setpoint"
8.29 "Buttons on product" ("Enable/disable settings")
8.40 "Assist"
8.44 "Multi-pump setup" ("Setup of multi-pump system")
7.2.2
Startup guide
The pump incorporates a startup guide which is started at the first
startup. See the section on running the startup guide. After the
startup guide, the main menus appear in the display.
Related information
8.37 "Run start-up guide"
8.37 Consultez guide de démarrage
8.37 “Ejecutar guía de config. inicial”
24
English (US)
To Next Page
Loading...
Need help?
General
