8.25 "Radio communication" ("Enable/disable radio
comm.")
Pump variant
"Radio communication" ("Enable/
disable radio comm.)
CME ●
CRE, CRIE, CRNE, CRKE,
SPKE, MTRE
●
You can set the radio communication to either enabled or disabled.
You can use this function in areas where radio communication is not
allowed.
IR communication remains active.
Factory setting
See the section on factory settings.
Related information
9.2 Factory settings
8.26 "Language"
Pump variant "Language"
CME ●
CRE, CRIE, CRNE, CRKE, SPKE,
MTRE
●
This menu is only available in the advanced operating panel.
In this menu, you select the desired language. A number of
languages is available.
Factory setting
See the section on factory settings.
Related information
9.2 Factory settings
8.27 "Date and time" ("Set date and time")
Pump variant
"Date and time"
("Set date and time")
CME ●
CRE, CRIE, CRNE, CRKE,
SPKE, MTRE
●
The availability of this menu depends on the functional module fitted
in the pump:
Function (terminal)
FM 200
1)
(standard)
FM 300
1)
(advanced)
"Date and time" - ●
1)
See the section on the identification of functional module.
You can set date and time as well as how you want them to be
viewed in the display:
• "Select date format":
"YYYY-MM-DD"
"DD-MM-YYYY"
"MM-DD-YYYY".
• "Select time format":
"HH:MM 24-hour clock"
"HH:MM am/pm 12-hour clock".
• "Set date"
• "Set time".
Factory setting
See the section on factory settings.
Related information
3.2.2 Identification of functional module
9.2 Factory settings
8.28 "Unit configuration" ("Units")
Pump variant
"Unit configuration"
("Units")
CME ●
CRE, CRIE, CRNE, CRKE, SPKE,
MTRE
●
In this menu, you can select between SI and US units. The setting
can made generally for all parameters or you can customize for
each parameter.
Factory setting
See the section on factory settings.
Related information
9.2 Factory settings
8.29 "Buttons on product" ("Enable/disable settings")
Pump variant
"Buttons on product"
("Enable/disable settings")
CME ●
CRE, CRIE, CRNE, CRKE,
SPKE, MTRE
●
In this display, you can disable the possibility of making settings for
protective reasons.
Grundfos GO Remote
If you set the buttons to "Not active" the buttons on the
standard operating panel are disabled. If you set the buttons to "Not
active" on pumps fitted with an advanced operating panel, see
below.
Advanced operating panel
If you have disabled the settings, you can still use the buttons to
navigate through the menus, but you cannot make changes in the
"Settings" menu.
When you have disabled the possibility to make settings, the
symbol appears in the display
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
.
Advanced operating panel:
To unlock the motor and allow settings, press
and
simultaneously for at least 5 seconds.
Standard operating panel:
The button always remains active but you can only
unlock all other buttons on the motor with Grundfos
GO Remote.
Factory setting
See the section on factory settings.
Related information
9.2 Factory settings
53
English (US)
To Next Page
Loading...
Need help?
General
