Grundfos CRE - Page 26

"Settings"
"Settings"
CRE, CRIE, CRNE, CRKE,
SPKE, MTRE
CME Multipump system
"Setpoint" ● ● ●
"Operating mode" ● ● ●
"Set manual speed" ● ● ●
"Control mode" ● ● ●
"Analog inputs" ● ● ●
"Analog input 1, setup" ● ● ●
"Analog input 2, setup" ● ● ●
"Analog input 3, setup" ● ●
●
1)
"Pt100/1000 inputs" ● ●
●
1)
"Pt100/1000 input 1,setup" ● ●
●
1)
"Pt100/1000 input 2,setup" ● ●
●
1)
"Digital inputs" ● ● ●
"Digital input 1, setup" ● ● ●
"Digital input 2, setup" ● ●
●
1)
"Digital inputs/outputs" ● ● ●
"Digital input/output 3, setup" ● ● ●
"Digital input/output 4, setup" ● ●
●
1)
"Signal relays" 1 and 2 ("Relay outputs") ● ● ●
"Relay output 1" ● ● ●
"Relay output 2" ● ● ●
"Analog output" ● ●
●
1)
"Output signal" ● ●
●
1)
"Function of analog output" ● ●
●
1)
"Controller" ("Controller settings") ● ● ●
"Operating range" ● ● ●
"Setpoint influence" ● ● ●
"External setpoint function" ● ● ●
"Predefined setpoints" ● ●
●
1)
"Monitoring functions" ● ● ●
"Motor bearing monitoring" ● ● ●
"Bearings replaced" ("Motor bearing maintenance") ● ● ●
"Limit-exceeded function" ● ● ●
"LiqTec" ("LiqTec function") ● ● ●
"Special functions" ● ● ●
"Stop function" ("Low-flow stop function") ● ● ●
"Pipe filling function" ● ● ●
"Pulse flowmeter" ("Pulse flowmeter setup") ● ● ●
"Ramps" ● ● ●
"Standstill heating" ● ● ●
"Communication" ● ● ●
"Number" ("Pump number") ● ● ●
"Radio communication" ("Enable/disable radio comm.") ● ● ●
"General settings" ● ● ●
"Language" ● ● ●
"Date and time" ("Set date and time") ● ● ●
"Unit configuration" ("Units") ● ● ●
"Buttons on product" ("Enable/disable settings") ● ● ●
26
English (US)