10
6. Start-up
Do not start the pump until the system has been filled
with liquid and vented. Furthermore, the required
minimum inlet pressure must be available at the
pump inlet, see section 11. Technical data.
The system cannot be vented through the pump.
The pump can be vented by slackening the
inspection screw.
Fig. 8 Venting the pump
Warning
If the inspection screw is to be
slackened, see fig. 8, care should be
taken to ensure that the escaping,
scalding hot liquid does not cause
personal injury or damage to
components.
TM02 5508 3402
Inspection screw
To Next Page
Loading...
Need help?
General
