Grundfos magna3 - MAGNA3 D Twin-Head Performance

MMMMM
T
T
M
» Boiler pump
» Shunt/buer
» ’Primary only’ system
» Hot water » Hot water
» Charging pump
» Recirculation
» Recirculation
» Fan coil unit
» Radiator two-pipe
system
» Radiator one-pipe
system
» Underoor/ceiling
» Air handling unit
Assist
The application wizard in the Assist menu helps
you set the correct control mode.
Firstly, identify your pump in the application
overview below. Secondly, in the pump’s display,
choose the system that applies to the position of
your pump.
Example: Boiler pump
Choose “Boiler pump” in the application wizard
and press “OK”. Then select either “’Primary only’
system” or “Shunt/buer” depending on the posi-
tion of the pump. Press “OK”. Keep choosing the
characteristics corresponding to your system until
the setup is complete.
4
Application wizard
Heating and hot water systems
4