Grundfos RADIOMODULE 2G4 - Page 30

H
Q
TM054895
Related information
6.5 "Control mode"
5.1.2.3 Setting to maximum speed
The motor must not be in operating mode Stop.
• Press and hold the Up button until the top light field is on and starts flashing.
H
Q
TM054896
5.1.2.4
Setting to minimum speed
The motor must not be in operating mode Stop.
• Press and hold the Down button until the bottom light field is on and starts flashing.
H
Q
TM054897
5.1.2.5
Starting the motor
How you start the motor depends on how it was stopped.
• Start the motor in one of the following ways:
- If the motor was stopped by pressing the Start/Stop button: Start the motor by pressing the Start/Stop button.
- If the motor was stopped by pressing and holding the Down button: Start the motor by pressing and holding the Up button.
5.1.2.6
Stopping the motor
• Stop the motor in one of the following ways:
- Press the Start/Stop button.
- Press and hold the Down button until all light fields are off.
- Use Grundfos GO Remote.
- Use a digital input set to External stop.
5.1.2.7
Resetting alarms and warnings in products with a standard operating panel
• You can reset a fault indication in one of the following ways:
- Briefly press the Up or Down button.
This is not possible if the buttons have been locked.
This does not change the setting of the motor.
30
English (GB)