Settings MGE Multimotor system
Relay output 2 • •
Analog output
*
• •
Output signal
*
• •
Function of analog output
*
• •
Controller settings • •
Operating range • •
Setpoint influence • •
Ext. setpoint infl. • •
Predefined setpoints
*
• •
Monitoring functions • •
Motor bearing monitoring • •
Alarm handling
Motor bearing maintenance • •
Limit-exceeded function • •
Special functions • •
Stop at min. speed
Ramps • •
Standstill heating • •
Direction of rotation
Communication • •
Pump number • •
Enable/disable radio comm. • •
General settings • •
Language • •
Set date and time • •
Units • •
Enable/disable settings • •
Delete history • •
Define Home display • •
Display settings • •
Store actual settings • •
Recall stored settings • •
Run start-up guide • •
*
Only available if an advanced functional module, type FM 300, is fitted.
Assist
MGE Multimotor system
Assisted pump setup • •
Setup, analog input • •
Setting of date and time • •
Setup of multi-pump system • •
Description of control mode • •
Assisted fault advice • •
Related information
6. Setting the product
5.2 Grundfos GO Remote
The product is designed for wireless radio or infrared communication with Grundfos GO Remote.
34
English (GB)
To Next Page
Loading...
