6.5 "Control mode"
You can choose between the following control modes:
• Const. other val. (constant other value)
• Const. curve (constant curve)
Related information
5.1.2.2 Setting the setpoint in constant curve mode
5.1.2.1 Setting the setpoint in constant parameter mode
6.1 "Setpoint"
6.13 "Operating range"
6.47 "Description of control mode"
6.5.1 "Constant other value"
Use this control mode to control a value which is not available in the Control mode menu. To measure the controlled value, connect a sensor
to one of the analog inputs. The controlled value is shown in percentage of the sensor range.
6.5.2 "Constant curve"
Use this control mode to control the motor speed.
You can set the desired speed in percentage of the maximum speed in the range from user-set minimum speed to user-set maximum speed.
TM057957
Related information
6.13 "Operating range"
6.6 "Analog inputs"
The inputs and outputs available depend on the functional module fitted in the motor.
Functional module
Analog input 1
(Terminal 4)
Analog input 2
(Terminal 7)
Analog input 3
(Terminal 14)
FM 100 (basic) • - -
FM 200 (standard) • • -
FM 300 (advanced) • • •
To set the input, make the settings below:
Function
You can set the inputs to these functions:
• Not active
• Feedback sensor
The sensor is used for the selected control mode.
• Setpoint influence
The input signal is used for influencing the setpoint.
• Other function
The sensor input is used for measurement or monitoring.
40
English (GB)
To Next Page
Loading...
