5.1.3.1 Home display
Setpoint
5.00 bar
Operating mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3 4
56789
Home
TM064516
Pos. Symbol Description
1
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Home: This menu shows up to four user-defined parameters. You can access each of the parameters directly from this
menu.
2 - Status: This menu shows the status of the product and system as well as warnings and alarms.
3 -
Settings: This menu gives access to all setting parameters. The menu also allows you to make detailed settings of the
product.
4 - Assist: This menu enables assisted setup, provides a short description of the control modes and offers fault-finding advice.
5
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Start/Stop: The icon indicates that the product has been stopped by means of the Start/Stop button.
6
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Master: The icon indicates that the product is functioning as the master in a system with products of the same type and
size.
7
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Slave: The icon indicates that the product is functioning as a slave in a system with products of the same type and size.
8
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Multioperation: The icon indicates that the product is operating in a system with products of the same type and size.
9
Setpoint
5.00 bar
Operaring mode
Normal
Actual controlled value
4.90 bar
Control mode
Const. pressure
Status Settings Assist
1 2 3
56789
Lock: The icon indicates that the possibility to make settings has been disabled for protective reasons.
5.1.3.2 Startup guide
The function is only available in the advanced operating panel.
The startup guide starts at the first startup and guides you through the settings needed for the product to operate in the given application.
When the startup guide has been completed, the main menus appear in the display.
You can always run the startup guide at a later time.
5.1.3.3
Menu overview for the advanced operating panel
Home MGE Multimotor system
• •
Status MGE Multimotor system
Operating status • •
Operating mode, from • •
Control mode • •
Pump performance • •
Actual controlled value • •
Resulting setpoint • •
Speed • •
Acc. flow and specific energy • •
Power and energy consumption • •
Measured values • •
Analog input 1 • •
32
English (GB)
To Next Page
Loading...
