English (GB)
4
2. Safety
For safety reasons, all work in pits must be supervised by a
person outside the pump pit.
Pits for submerged sewage and wastewater pumps contain
gasses and wastewater with toxic and/or disease-causing
substances. Therefore, all persons involved must wear
appropriate personal protective equipment and clothing, and all
work on and near the pump must be carried out under strict
observance of hygienic regulations in force.
3. Receiving the product
3.1 Transporting the product
You can transport the pump in vertical or horizontal position.
Make sure that the pump cannot roll or fall over.
3.2 Contaminated products
For further information, see the installation and operating
instructions for SE1, SEV, 1.1 - 11 kW. The installation and
operating instructions are accessible via the QR code and link on
the front page of this document.
4. Storing and handling the product
4.1 Storing the product
During long periods of storage, the pump must be protected
against moisture and heat.
For further information, see the installation and operating
instructions for SE1, SEV, 1.1 - 11 kW. The installation and
operating instructions are accessible via the QR code and link on
the front page of this document.
4.2 Handling the pump
The SE1, SEV 1.1 - 11 kW pumps weigh between 86 and 216 kg
without accessories. It is therefore very important to use the
correct lifting equipment. The pump weight is stated on the pump
nameplate.
4.2.1 Lifting the product
For horizontal, dry-installed pumps, a special lifting bracket can
be ordered to ease the lifting of the pump. See 7.2 Lifting tools.
5. Identification
You can find an example of a nameplate and the explanation of
the type key in the installation and operating instructions for SE1,
SEV 1.1 - 11 kW.
The installation and operating instructions are accessible via the
QR code and link on the front page of this document.
Pump installation in pits must be carried out by
specially trained persons.
Work in or near pits must be carried out according to
local regulations.
DANGER
Electric shock
Death or serious personal injury
- It must be possible to lock the main switch in
position 0. Type and requirements as specified in
EN 60204-1, 5.3.2.
Persons must not enter the installation area when the
atmosphere is explosive.
We recommend that you carry out all maintenance
and service work when the pump is placed outside
the pit.
DANGER
Crushing hazard
Death or serious personal injury
- Always lift the pump by its lifting bracket or by
means of a forklift truck if the pump is on pallet.
- Never lift the pump by the power cable or the hose
or pipe.
CAUTION
Biological hazard
Minor or moderate personal injury
- Flush the pump thoroughly with clean water and
rinse the pump parts in water after dismantling.
Rate all lifting equipment for the purpose, and check
for damage before any attempts are made to lift the
pump. Do not under any circumstances exceed the
rated data.
DANGER
Crushing hazard
Death or serious personal injury
- Always lift the pump by its lifting bracket or by
means of a forklift truck if the pump is on pallet.
DANGER
Electric shock
Death or serious personal injury
- Never lift the pump by the power cable.
WARNING
Crushing hazard
Death or serious personal injury
- Make sure that the lifting bracket is tightened
before attempting to lift the pump. Tighten if
necessary.
To Next Page
Loading...
Need help?
General
