English (GB)
21
Settings
TPE3
TPE3 D
TPE2
TPE2 D
Multipump
system
Section Page
Setpoint 14.2 Setpoint 27
Operating mode 14.3 Operating mode 27
Set manual speed 14.4 Set manual speed 27
Control mode 14.5 Control mode 28
FLOW
LIMIT
14.6 FLOWLIMIT 33
Automatic Night Setback -
14.7 Automatic Night
Setback
33
Analog inputs
14.8 Analog inputs 33
Analog input 1, setup
Analog input 2, setup
Analog input 3, setup
1)
1)
1)
Built-in Grundfos sensor -
14.9 Built-in Grundfos
sensor
34
Pt100/1000 inputs
1)
1)
1)
14.10 Pt100/1000 inputs 35Pt100/1000 input 1, setup
1)
1)
1)
Pt100/1000 input 2, setup
1)
1)
1)
Digital inputs
14.11 Digital inputs 35Digital input 1, setup
Digital input 2, setup
1)
1)
1)
Digital inputs/outputs
14.12 Digital inputs/outputs 36Digital input/output 3, setup
Digital input/output 4, setup
1)
1)
1)
Relay outputs
14.13 Signal relays 1 and 2
(Relay outputs)
36Relay output 1
Relay output 2
Analog output
1)
1)
1)
14.14 Analog output 37Output signal
1)
1)
1)
Function of analog output
1)
1)
1)
Controller settings
14.15 Controller (Controller
settings)
38
Operating range 14.16 Operating range 39
Setpoint influence
External setpoint function
14.17 External setpoint
function
39
Predefined setpoints
1)
1)
1)
14.18 Predefined setpoints 42
Temperature influence - 14.19 Temperature influence 42
Monitoring functions
Motor bearing monitoring
14.24 Motor bearing
monitoring
44
Motor bearing maintenance
Bearings replaced (Motor
bearing maintenance)
44
Limit-exceeded function -
14.20 Limit-exceeded
function
43
Special functions
Pulse flowmeter setup - 14.21 Pulse flowmeter setup 43
Ramps - 14.22 Ramps 44
Standstill heating 14.23 Standstill heating 44
Communication
Pump number
14.26 Number (Pump
number)
44
Enable/disable radio comm.
14.27 Radio communication
(Enable/disable radio
comm.)
45
General settings
Language 14.28 Language 45
Set date and time
14.29 Date and time (Set
date and time)
45
Units
14.30 Unit configuration
(Units)
45
To Next Page
Loading...
