Grundfos TPE 2 Series - Factory Settings

English (GB)
64
31. Factory settings
*)
Only available if you have fitted an advanced functional module, FM 300.
 Function is enabled.
❍
Function is disabled.
- Function is not available.
Settings TPE3, TPE3 D TPE2, TPE2 D
Function
description on
page
Setpoint Auto  27
Operating mode Normal Normal 27
Control mode AUTO
ADAPT
Const. curve 28
Date and time 
*)

*)
FLOWLIMIT
❍
-
Automatic Night Setback
❍
-
Temperature influence
❍
-
Buttons on product 45
Controller (Controller settings) 38
Ti 1.0 0.5
Kp 8.0 0.5
Operating range 39
Min. 25 % 25 %
Max. 100 % 100 %
Ramps -
❍
44
Ramp-up 1 second 1 second
Ramp-down 3 seconds 3 seconds
Number (Pump number) 1 1 44
Radio communication 45
Analog input 1
❍❍
33Analog input 2
❍❍
Analog input 3
❍❍
Built-in Grundfos sensor  -
34
Grundfos differential pressure sensor Feedback sensor -
Grundfos temperature sensor
❍
-
Pt100/1000 input 1
❍❍
35
Pt100/1000 input 2
❍❍
Digital input 1
❍❍
35
Digital input 2
❍❍
Digital in/output 3
❍❍
36
Digital in/output 4
❍❍
Pulse flowmeter
❍❍
43
Predefined setpoints
❍❍
42
Analog output
❍❍
37
External setpoint function
❍❍
39
Signal relay 1
❍❍
36
Signal relay 2
❍❍
Limit 1 exceeded -
❍
43
Limit 2 exceeded -
❍
Standstill heating
❍❍
44
Motor bearing monitoring
❍❍
44
Pump name Grundfos Grundfos 46
Connection code - - 46
Unit configuration SI SI 45