OIL TEMPERATURE
TOO HIGH
Insufficient amount of refrigerant
Slack water pump drive belt
Obstruction of radiator ducts
Defective radiator cap
High or low oil level
Obstruction in the exhaust system
Malfunction or improper use of the cold start system
Injector failure
Failure of the feeding pump
Speed control problems
Injector Failure
Motor support problem
Wear of the engine bearings
Inadequate fuel
Failure of fuel regulator
Damper malfunction (vibration damper)
Wear of piston and/or sleeve segments
Air intake obstruction
Damaged fan
Failure in the Inlet and/or exhaust valves
ENGINE STROKE
VIBRATIONS
BAD COMPRESSION
Injector failure
Failure of the feeding pump
Failure of fuel regulator
Inadequate fuel
Malfunction or improper use of the cold start system
Use of improper or excessive oil
Failure in the Inlet and/or exhaust valves
AVARIA
CAUSA POSSÍVEL
For more information about using the generator controller, go to the Deep Sea web site
where you can download the complete manual at:
http://www.deepseaplc.com/support/productdownloads/
OPERATION
07.
The genset control is performed through the DSE 3110, which gives the group 2 operating
modes:
7.1. DSE 3110
To Next Page
Loading...
