7.6.1. AUTOMATIC MODE
Activate the automatic mode by pressing the button . A LED indicator next to the
button will confirm this action.
The automatic mode will allow the generator to fully operate automatically, starting and
stopping when necessary, without user intervention.
If there is a boot request the group will start the boot sequence. Stabilizing prior to loading.
At the moment that the start request stops, the stop sequence starts after a predeter-
mined time, the circuit breaker opens. It then starts cooling down and then stops the
group.
7.6.2. MANUAL MODE
It is used to start and stop the group at will of the operator.
This mode is activated by pressing the / ,nevertheless to start the startup
sequence it is necessary to press . The load will not be transferred to the generator
until you press , because only then is the generator circuit breaker closed.
If there is no voltage, the breaker in the group will be switched off. If voltage is present, the
synchronization will occur first and then the group breaker will be switched off.
To stop the generator you will have to press , To stop the generator you will have to press
button , the group will check the boot requests and start the auto-stop sequence.
7.7. DSE 8620
Charge to the
generator transferency
(Manual)
allows generator charging
On Mode selection
allows the generator to start
Mute Siren / Lamps Test
mute the audible alarms and
turn on all the LEDs as a test
Auto mode selection
sets the group to auto mode
Charge to the network
transferency
(Manual)
allows charging
through thenetwork
Off mode selection
llows the generator to
stop and reset
Instrumentation and control screenNavigation keys
navigation between
information such as
instrumentation values of
the generator, network, etc
Manual Mode Selection
allows manual start
Test mode selection
allows test mode activation
Figure 27 - DSE 8620
To Next Page
