25
P202 Parity (Comm 1) (Selection)
Select Odd, Even or None for the transmission parity.
P203 Stop Bits (Comm 1) (Toggle)
Select 1 or 2 stop bits for communication port transmissions.
P204 Comm Handshake (Comm 1) (Selection)
Select from None, Software (Xon/Xoff), Hardware (CTS/RTS), or Both.
P210 Send (Comm 1) (Selection)
Transmission Send options:
Choice Number Selection Name Description
P210.00 Off All transmissions disabled.
P210.01 Press Sends transmission with [PRINT] key.
P210.02 Cont. Sends transmissions continuously.
P210.03 Cycle
Send single transmission after weight is reached and motion ceases. Must
return display value below 0.1% of F.S. to reset for next transmission.
P210.04 ID Sends transmission with the stored ID.
P212 Send Stability (Comm 1) (Toggle)
Enabling Send Stability will delay any transmissions until a no-motion condition exists.
P213 Transmit Selection (Comm 1) (Selection)
Select desired print output (1 - 16 or custom). The transmission will be initiated by the selected
print operation (P210) and / or the Remote Key selection (P800). See page 29 for details on
preset formats or page 31 for details on custom transmit.
P220 Baud (Comm 2) (Selection)
Set the desired baud rate for the communication port. 150 - 115K bps
P221 Data Bits (Comm 2) (Toggle)
Select 7 or 8 data bits for the transmission.
P222 Parity (Comm 2) (Selection)
Select Odd, Even or None for the transmission parity.
P223 Stop Bits (Comm 2) (Toggle)
Select 1 or 2 stop bits for communication port transmissions.
P224 Comm Handshake (Comm 2) (Selection)
Select from None and Software (Xon/Xoff).
P230 Send (Comm 2) (Selection)
Transmission Send options:
Choice Number Selection Name Description
P230.00 Off All transmissions disabled.
P230.01 Press Sends transmission with [PRINT] key.
P230.02 Cont. Sends transmissions continuously.
P230.03 Cycle
Send single transmission after weight is reached and motion ceases. Must
return display value below 0.1% of F.S. to reset for next transmission.
P230.04 ID Sends transmission with the stored ID.
P232 Send Stability (Comm 2) (Toggle)
Enabling Send Stability will delay any transmissions until a no-motion condition exists.
To Next Page
Loading...
