EasyManua.ls Logo

GSK DA98A - User Manual

GSK DA98A
80 pages
Save Page as PDF
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DA98A AC SERVO DRIVE UNIT
User Manual
(Version 3.00)

Table of Contents

Questions and Answers

  • A
    Andrew LarsenAug 18, 2025
    Why does my GSK Controller show overspeed?
    • T
      Theresa ParkerAug 18, 2025
      The overspeed issue in the GSK Controller can stem from several root causes. It might be triggered by a fault in the control circuit board, or an encoder fault. Additionally, the pulse frequency of the input instruction could be excessively high, or the acceleration/deceleration time constant might be set too low, leading to substantial speed overshooting. Furthermore, an improperly configured input electronic gear ratio, an inferior encoder cable, or an unstable servo system could also be contributing factors.
  • M
    Meagan GarciaNov 1, 2025
    What to do if GSK DA98A Controller shows overspeed?
    • F
      Frances BurnsNov 1, 2025
      If the GSK Controller experiences overspeed, it may be due to several factors. First, ensure that the input instruction pulse is correctly set, as a pulse frequency that is too high can cause this issue. Another potential cause is an acceleration/deceleration time constant that is too small, leading to significant speed overshooting; try increasing this constant. Additionally, verify that the input electronic gear ratio is correctly configured, as an excessively large ratio can contribute to overspeed. Also, the servo system may be unstable, resulting in overshooting. In this case, try setting the related gain again. Other possible solutions include changing the AC servo drive unit, changing the servo motor, changing the encoder cable, reducing the load inertia and connecting the wire corr...

Summary

WARNINGS

Connection

Critical safety and wiring precautions.

Troubleshooting

Safety during maintenance.

CHAPTER 2 INSTALLATION

Installation of AC servo drive unit

Guidelines for mounting the drive unit.

Servo motor installation

Guidelines for mounting the servo motor.

CHAPTER 3 WIRING

Standard wiring

Illustrates typical connection diagrams.

Terminals function

Details the purpose of each terminal.

CHAPTER 4 PARAMETERS

Parameter list

Comprehensive list of configurable parameters.

Parameter function

Explains the meaning and use of each parameter.

CHAPTER 5 ALARM AND TROUBLESHOOTING

Alarm list

Alarm troubleshootings

Provides solutions for common alarm conditions.

CHAPTER 6 DISPLAY AND OPERATION

Monitoring mode

Parameter setting

Step-by-step guide to adjust parameters.

Parameter management

CHAPTER 7 RUNNING

Power supply connection

Trial run

Adjustment

Guidance on tuning control loops for optimal performance.

GSK DA98A Specifications

General IconGeneral
Display7-inch color LCD
Minimum command unit0.001mm
Spindle override50%~120%
MPGYes
Acceleration/deceleration modeLinear, S-curve
Interpolation modeLinear, circular
PLC functionYes
InterfaceUSB, RS232
Protection FunctionsOvervoltage, overcurrent
Operating Temperature0°C to 45°C
Storage Temperature-20°C to 60°C

Related product manuals