Method
The Master user sends following SMS message in order to:
Enable timing switch on the output: #128#1# (18)
Successful SMS reply
Schedule control: function ON
WorkDay, StartTime-EndTime
If the value of the “WorkDay, StartTime, EndTime” on the SMS
reply are all 0, it means the time duration has not been set. (Refer
to 3.4.2)
Then GSM Power Socket will keep switching on or off the output
automatically according to the schedule settings.
3.5.2 Set time period to switch on the output
Description
After successful setting of time duration to switch on the socket
output, the schedule parameter will be saved on the socket until
GSM Power Socket is reset to factory settings.
But the “timed switch on the output” feature is applied only when
command 17 be set.
Method
The Master user sends following SMS message in order to:
Set time period to switch on the output:
#129#WorkDay#StartTime#EndTime# (19)
WorkDay: one digit, the values lie in the range of “0” to “8”.
The following table contains the descriptions of each value:
To Next Page
Loading...