The Master user sends following SMS message in order to:
Enable the “Beep” warning tone: #19#1# (34)
Disaable the “Beep” warning tone (Default): #19#0# (35)
Successful SMS reply
Beep alarm activated/de-activated.
3.11 Check status
Method
The Master user sends following SMS message in order to:
Check socket operating status: #07# (36)
After receiving the SMS commands, GSM Power Socket will reply one
SMS message of socket status checking:
Number:***********,**********
Status: ON/OFF
TEMP:**
Temp control:function ON/OFF
Schedule control:function ON/OFF
Delay control:function ON/OFF
Check socket output status: #000# (37)
After receiving the SMS commands, GSM Power Socket will reply one
SMS message of socket output status:
Status: ON
Temp:23.
Check “delayed switch on/off the socket” parameters: #138# (38)
After receiving the SMS commands, GSM Power Socket will reply one
SMS message of “Delayed switch on/off the socket” parameters
checking:
Status: ON/OFF
Output will switch off/on after ** minutes.
Check “Timing switch on the socket” parameters: #128# (39)
After receiving the SMS commands, GSM Power Socket will reply one
To Next Page
Loading...
General