Gtec NOVA 10kVA - System Settings

www.gtec-power.de 41
83
Input Volt Detect Fail-Set
Input Voltage is abnormal
84
Input Volt Detect Fail-Clear
Alarm disappears
85
Battery Volt Detect Fail-Set
Battery Voltage is abnormal
86
Batt Volt Detect Fail-Clear
Alarm disappears
87
Output Volt Fail-Set
Output Voltage is abnormal
88
Output Volt Fail-Clear
Alarm disappears
89
Outlet Temp. Error-Set
Outlet Temperature is abnormal
90
Outlet Temp. Error-Clear
Alarm disappears
91
Input Curr Unbalance-Set
Input current is not balance
92
Input Curr Unbalance-Clear
Alarm disappears
93
DC Bus Over Volt-Set
DC bus over Voltage
94
DC Bus Over Volt-Clear
Alarm disappears
95
REC Soft Start Fail-Set
Rectifier soft start fails
96
REC Soft Start Fail-Clear
Alarm disappears
97
Relay Connect Fail-Set
Relay in open circuit
98
Relay Connect Fail-Clear
Alarm disappears
99
Relay Short Circuit-Set
Relay shorted
100
Relay Short Circuit-Clear
Alarm disappears
101
No Inlet Temp. Sensor-Set
The inlet temperature sensor is not connected or
abnormal
102
No Inlet Temp Sensor-Clear
Alarm disappears
103
No Outlet Temp. Sensor-Set
The Outlet temperature sensor is not connected or
abnormal
104
No Outlet Temp Sensor-Clear
Alarm disappears
105
Inlet Over Temp.-Set
Inlet over temperature
106
Inlet Over Temp.-Clear
Alarm disappears
3.3.3 Setting
Touch the “Setting” icon, the system enters the page of Setting, as it is shown in Figure 3-4.