37
TROUBLESHOOTING GUIDE, CONTINUED….
On some applications it is necessary to move the two (2) Support Rollers (item #2 below) closer to
the Main Roller to prevent the machine, or plate, from ‘kicking/bucking’ at the start and at the end of
the bevel, thereby providing a more constant bevel across the whole edge of the plate.
It may also be necessary to move the Support Rollers to the inner holes of the Support Roller Plate
when bevelling malleable material, especially thin malleable plate. This will provide support to the
plate closer to where the material is being sheared, thus reducing plate deformation and improving
the starting feed.
Move Support Rollers to
inner holes
To Next Page
Loading...