GW Instek GDS-207 - Running a Go-Nogo Test

GDS-200 & GDS-300 Series User Manual
122
Running a Go-NoGo Test
Background
The Go-NoGo controls are located at the
bottom left-hand corner of the screen. The
Fail/Total ratio (Violations/Number of Tests) is
shown in the title bar.
Fail/Total ratio
Go-NoGo controls
Run Go-NoGo
Test
1. Toggle the Go-NoGo button from pause to
play.
→
The test will run continuously until the test is
stopped.
Pressing the Go-NoGo button again will stop
the test and toggle the button back to pause.
If the Violating setting was set to Stop or Stop
Beep, press the Go-NoGo button again to
restart the test after it has stopped.