GW Instek GDS-2072A - Page 178

GDS-2000A Series User Manual
178
Choose the Go_NoGo application
from the APP. menu. See page 175.
Set Go-NoGo
Conditions
Select the Go-NoGo conditions (NG When) and
actions when a Go-NoGo condition has been met
(Violating).
1. Press NG When from the bottom
menu and select the NoGo
conditions:
Enters: Sets the NoGo condition to
when the input signal stays within
the limit boundary.
Exits: Sets the NoGo condition to
when the input signal exceeds the
limit boundary.
2. Press Go Back to return to the
previous menu.
Set Go-NoGo
Actions
1. Press Violating to set what action to
perform when a signal is violating
the Go-NoGo conditions.
The waveform stops when the
conditions are violated.
The waveform stops and a beep will
be output when the conditions are
violated.
Ignore violations and continue to
monitor the signal.
Output a beep when a violation
occurs, but continue to monitor the
signal.
w ww . . co m
information@itm.com1.800.561.8187