GW Instek GOM-802 - Page 14

GOM-802 User Manual
14
 Sample speed
The REL%
VALUE
key is used to perform
a zero adjustment to the test leads or a
DUT. Using the shift key will display
the measured values as a percentage of
the normal value.
 Percentage
values
The LOCAL
GPIB/RS232
key will switch the
milliohm meter between local and
remote mode.
The secondary function will set the I/O
interface to GPIB or RS-232.
 GPIB/
RS232 mode
Sets the High limit % values. The
secondary function activates the
Handler function.
SHIFT
HANDLER
HIGH
 Handler mode
Sets the normal (Nominal) value for the
comparator function.
 Scan function
Sets the lower % limit for the
comparator function and turns the
buzzer on for either a PASS or FAIL
judgment or turns the buzzer off.
 Buzzer
ON/OFF