GW Instek GOM-802 - Interface; Environmental; General

APPENDIX
53
Interface
Handler interface* Signal: START TTL input
Signal: LOW, HIGH, FAIL, PASS, EOT, READY total 6 TTL
outputs.
(This function is valid only under the resistance
measurement mode and the compare mode is enabled.)
Scan* Signal: READY, PASS, LOW, HIGH, CLOCK, STRB total 6
TTL outputs.
(This function is valid only under the resistance
measurement mode and the compare mode is enabled.)
RS-232+ GPIB (option)
IEEE488.1-1987, IEEE488.2-1992 and SCPI-1994
* The Scan and Handler interface use the same
connector
Environmental
Operation
Environment
Indoor use, altitude up to 2000m.
Ambient Temperature 0˚C to 40˚C.
Relative Humidity 80% (Maximum).
Installation category II
Pollution Degree 2
Storage temperature -10˚C to 70˚C.
General
Power source
AC 100V/120V/220V/230V±10%, 50/60Hz, 27VA, 22W.
Accessories Test Lead × 1, User manual × 1,
Programmable manual × 1 (option),
Temperature sensor (option) × 1
Dimension 251(W)×91(H)×291(D) mm
Weigh Approx. 3 kg