MEASUREMENT
27
The GO, HI or LO indicators will light up for each
measured value that is compared to the upper and lower
limits.
1. Select the
compare function
Press COMP
EMP
to access the
compare mode, as shown above.
2. Normal value
setting
Press NORMAL
SCAN
to set
NORMAL value setting.
Use the Left and Right arrow keys to
select a digit. The selected digit will
flash.
Use the Up and Down arrow keys to
edit the value of the selected digit.
Range 33000~00000
Press ENTER to confirm the setting.
Note
After setting the Normal value, the HI and LO limits will
be changed to reflect the new Normal value setting.
3. HI limit
setting
Press HIGH
SCAN
to set the HI
percentage limit.
Use the Left and Right arrow keys to
select a digit. The selected digit will
flash.
To Next Page
Loading...
