0x0D 0x0D 0x0A as shown in the diagram below.
When setting is without A, the terminator for
responsed message on the display is 0x0D 0x0A as
shown in the diagram below.
On the other hand, you can judge if setting is with
A by the readback voltage value.
When you see the readback voltage value insert an
“0”digit before first digit if for voltage value less
than 10, it means that setting is with A.
For example, if readback voltage value is 5V as the
diagram shown below, it means that setting is
with A.
To Next Page
Loading...
