transparency function will be activated.
After the vehicle bottom transparency function is activated, the image interface will
gradually display the image of the road under the vehicle as the vehicle moves.
〉
Radar Display
Touch the radar display setting button repeatedly to change the radar display
mode. After the setting is shown and when an obstacle is detected, a radar identi-
cation will be shown in the obstacle direction.
View switch
Automatic view switch
When D gear is engaged, it will automatically switch to the front view image; when R
gear is engaged, it will automatically switch to the rear view image; in D gear, turn on
the left turn signal lamp and the image area will be automatically switched to the left
front wheel image, or turn on the right turn signal lamp and the image area will be
automatically switched to the right front wheel image.
Manual view switch
When the speed of the vehicle is less than 10 km/h, you can switch the perspective
manually.
In 2D mode, you can touch the surrounding area of the vehicles in the top view to
switch to the related view image where the area is located.
When the 3D mode is turned on, tap the top view area, then the top view will display
the multi-directional buttons. Tap to select the button indicating each direction, then
the image area will display the view image corresponding to this button.
60DA38DF374C
Ⓐ Engine compartment transparent view button
In 3D view mode, tap the transparent view button of the engine compartment, then
118
2
Driving
To Next Page
Loading...