H3C S1600V2 Series User Manual

1
Preparing for installation
This document is applicable to the S1600V2 switch series. Table 1 describes the S1600V2 switch
series models.
Table 1 Product models
Product series
Product codes
Product models
S1600V2 series
Non-PoE
models
LS-1600V2-6P-GL S1600V2-6P
LS-1600V2-10P-GL S1600V2-10P
LS-1600V2-18P-GL S1600V2-18P
LS-1600V2-26P-GL S1600V2-26P
PoE models
LS-1600V2-6P-HPWR-GL S1600V2-6P-HPWR
LS-1600V2-10P-HPWR-GL S1600V2-10P-HPWR
LS-1600V2-18P-HPWR-GL S1600V2-18P-HPWR
LS-1600V2-26P-HPWR-GL S1600V2-26P-HPWR
NOTE:
•
For product selection and purchasing, see the switch datasheet at:
https://www.h3c.com/en/Products_and_Solutions/InterConnect/Switches/.
• For the compatibility between the product models and software versions, see the release notes.
Safety recommendations
CAUTION:
Only qualified professionals can install and remove the device and its attachments. Before
installation and operation, carefully read the provided security instructions.
To avoid possible environmental pollution and bodily injury, read the following safety precautions
before installing the device. Note that the precautions do not cover every possible hazardous
condition.
•
Before cleaning the switch, remove all power cords from the switch. Do not clean the switch
with wet cloth or liquid.
•
Do not place the switch near water or in a damp environment. Prevent water or moisture from
entering the switch chassis.
•
Do not place the switch on an unstable case or desk.
•
Ensure good ventilation at the installation site and keep the air inlet and outlet vents of the
switch free of obstruction.
•
Make sure the power source voltage meets the requirements of the switch.
•
To avoid electrical shocks, do not open the chassis while the switch is operating. As a best
practice, do not open the chassis even if the switch is powered off.

H3C S1600V2 Series Specifications

General

Brand	H3C
Model	S1600V2 Series
Category	Switch
Language	English