35
Displaying the operational status of power
modules
Use the display power command to display the operational status of power modules.
<Sysname> display power
Power 0 Status: Normal
Power 1 Status: Absent
Table 8 Output description
Field Description
Power Number of the power module.
Status
Power module state:
• Normal—The power module is operating correctly.
• Absent—The power module is not in position.
• Abnormal—The power module has failed.
Displaying the temperature information of the
firewall
Use the display environment command to display the temperature information of the firewall.
<Sysname> display environment
System Temperature information (degree centigrade):
--------------------------------------------------------------------------------
---------
Sensor Temperature LowerLimit Warning-UpperLimit Alarm-UpperLimit Shutdown-U
pperLimit
inflow 1 26 -5 48 56 NA
Table 9 Output description
Field Description
Sensor
Temperature sensor:
• inflow—Air inlet vent temperature sensor.
• outflow—Air outlet vent temperature sensor.
• hotspot—Hotspot temperature sensor.
Temperature Current temperature.
LowerLimit Low temperature alarm threshold.
Warning-UpperLimit Warning-level high temperature alarm threshold.
Alarm-UpperLimit Alarm-level high temperature alarm threshold.
Shutdown-Upperlimit
Shutdown-level high temperature alarm threshold. The firewall automatically
powers off when the temperature exceeds this threshold.
To Next Page
Loading...
Need help?
General
